SAAB Fuel Line 90deg Connector Holder Presstool

A robust holder for the SAAB 9-3 8mm (outer diameter) fuel line connector 90 degree angle. The holder holds the 90 degree connector securely centered and without any major pressurepoints. The pressing is done with an ordinary caulk/silicone gun. Use together with my other print that clamps onto the 8mm (outer) nylon fuel line in order to secure it while pressing! Link to print

After this connector broke on my car i were required to press on a new connector. I found one on the scrap yard and were able to repair the fuel line.

The print requires quite a lot of strength. I added a small hole in the middle to force the slicer to add walls right below where the most pressure is created while pressing. The fit is very snug, if its not sitting fully bottomed out you can use some hot water to dip the print into then force in the connector.