BRÄNNBOLL GamingStation Desk Foldable TableBracket
Print Profile(1)
Description
Something to stop the folding portion of the BRÄNNBOLL Gaming Station table top at an angle instead of going all the way to flat.
There's also some circular storage spots in the bottom part of the bracket.
Installation is with some double sided tape (3M 414 Scotch).
The rear edge of the bracket is positioned 125mm from the gap.
Measuring with a tape, some paper and a pencil will work fine.
If you prefer there's some installation gauge prints you can use.
Print as pictured. No supports needed.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (0)