Search models, users, collections, and posts
SEEP Point Motor Fitting Template
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
13 min
1 plate
Open in Bambu Studio
Boost
2
4
2
0
8
4
Released
Description
I needed a simple jig to fit several point motors, this is a simple 15 minute print with no supports.
Simply place the flat side on the layout board for the pilot fixing holes and flip it over to set the centre position of the motor.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (2)