Search models, users, collections, and posts
Yin Yang Coaster + Epoxy Resin
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
36 min
1 plate
Open in Bambu Studio
Boost
8
13
1
0
13
6
Released
Bill of Materials
List other parts
- Epoxy Resin x 1: the only recommendation that I can give is be aware that the ideal room temperature for Epxy is around 25° Celsius, if don't want to spend for super expensive resin even the cheap one wuold do the work
Description
I’m excited to share my very first published 3D model with the community! This is a printable coaster featuring an embossed Yin Yang symbol, designed to be enhanced with transparent two‑component epoxy resin for a glossy, professional finish.
🖨️ Print Specifications
- Layer height: 0.2 mm (recommended)
- Infill: 20–30% (base must be solid)
- Supports: Not required
- Bed adhesion: Brim or raft recommended
- Material: PLA, PETG, or ABS
✨ Post‑Processing
The coaster has Yin Yang cavities specifically designed to be filled with epoxy resin.
- After printing, pour resin into both cavities and let it cure according to the manufacturer’s instructions (usually 24h).
- For a flawless look, sand with fine sandpaper (1000–2000 grit).
- To clean, use only water—some kitchen soaps may leave marks on the resin.
⚙️ Difficulty Level
Medium – requires resin post‑processing.
This project is really special to me because it’s my first ever published model. I’d love to hear your thoughts, feedback, or suggestions for improvement.
Thank you for checking it out, and I hope you enjoy printing it as much as I enjoyed designing it!
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (1)