Search models, users, collections, and posts
Filament Spool Holder LOWCOST and FAST
IP Report
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
1.3 h
1 plate
Open in Bambu Studio
Boost
6
22
7
2
29
16
Released
Bill of Materials
List other parts
- Rundstab Buche 12mm , Länge 1m x 2: Bei Bedarf durch Absägen kürzen.
Description
Content has been automatically translated.
Where to put all the filament ??
And then the mess
And another spool fell off the shelf
This filament spool holder in the LOWCOST and FAST version provides a solution
The focus was on simplicity for easy and fast printing without frills
It should just hold the filament
Required for the 12.1mm bore in the holder are 2 beech wood rods from the hardware store (1m)
The length is easily adjusted to the shelf or cabinet by sawing
3 holders are intended per shelf or cabinet Or more if needed
If the holders are fitted with rubber feet or foam rubber on the underside, this is perfect against
slipping
Boost Me (for free)
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivatives
Comment & Rating (7)