Search models, users, collections, and posts
Fixed-wing/bird/fast-moving object tracking mount
IP Report
Print Profile(1)
0.2mm layer, 3 walls, 20% infill
Designer
1.5 h
1 plate
Open in Bambu Studio
Boost
2
2
0
0
2
0
Released
Description
Content has been automatically translated.
Additionally, a phone holder with a ball-head link at the back is needed, as shown in the figure
13mm diameter carbon rod, length no less than 40cm
M3X25 screws 28 (more than 25 is fine)
To prevent slipping after installing the handle, you can apply some 3M double-sided tape on the carbon rod
Print with PLA or any rigid material
There are a total of 4 plates, pay attention to the names, if you don't understand, you can watch the video demonstration multiple times, once printed, you'll understand, no further explanation will be provided here
Video instructions
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivatives
Comment & Rating (0)