TIG-Tube | The easy storage solution for your TIG-Wire! feat. HTEM DN50 - Free 3D Print Model

Search models, users, collections, and posts

techam

Hobby & DIY>Other Hobby & DIY

IP Report

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

A1 mini

H2D

H2D Pro

H2S

P2S

H2C

X2D

A2L

0.2mm layer, 4 walls, 15% infill

Designer

1.6 h

1 plate

4.7(6)

Open in Bambu Studio

Boost

180

Released

Description

Easy storage solution for your TIG-Wire, using 1000mm HTEM-DN50-Tube.

Just cut the Tube at about 30mm from the female end, stick the long end into the Holders, and close the short end with the cap, boom! no more dust and gunk on your Tig-Wires.

Can also be used for any other long material, like threaded-rods etc.

I recommend to print a test of the cap at first, as the tubes ccan vary in diameter, so you may want to scale it slightly.

Have fun.

Comment & Rating (7)

@Gezef123

Boosted

Print Profile

0.2mm layer, 4 walls, 15% infill

the best

@APalu

Print Profile

0.2mm layer, 4 walls, 15% infill

The profile uploader has replied

@techam

Looks awesome! Love your idea to print the Material and thickness onto the caps! May do that myself.

@Osimb04

Print Profile

0.2mm layer, 4 walls, 15% infill

Printed these for some DN50 pipes, the fit was good but would like a thicker bottom (0.5-1 cm) as I planned to have threaded rods in the pipes. The model cracked when I put down threaded rod number 3. Another wish would be to have these for DN75, also there with a bottom that is about 0.5-1 cm

Strength Issue:The bottom is very thin.

Show original