Pegma: wall hanging system (hooks & hangers)

Pegma is a wall hanging system designed to be very efficient to print and assembly. It uses a single, minimal mounting bracket compatible with all available attachments. Current attachments include:

• Single hook;
• Double hook;
• Coat hanger;
• Towel holder;

Key features

• The bracket is ultra-light (just over 2g) and allows for easy tilting after drilling, so you can fine-tune the alignment before final tightening.
• The click-lock system keeps the attachments firmly in place, so they don’t pop off when you grab whatever’s hanging.
• Some parameters are customizable in the parametric model maker editor, allowing you to adapt some module to your specific needs.

What can you customize in the editor:

Length and height of the hooks.
Radius and offset of the Coat hanger module, as shown in the picture below:

⚠️ Keep in mind if you are using the parametric editor: When importing into Babustudio, click the “split objects" button in the upper bar, then “auto-orient”.
You'll need to set up supports under the coat hanger head if you print it. I can't do it from the file.

Assembly instructions

1. Use the bracket as a template to mark the two drilling points on the wall.
2. Drill the holes, then fully screw in the top screw and partially insert the bottom one.
3. Use a level to align the bracket, then tighten the bottom screw.
4. Slide the desired attachment down onto the bracket until you hear a “click,” confirming the lock.

A moment of your time

As a small designer, is getting harder and harder to get views on new models.

If you like what you see, please hit the like button. It REALLY helps.

If you like what I do, follow me.

If you want to support the model to improve:

How I will improve the model if it get enough attention

• Key hanging module;
• planter module?
• shelves system base on the same mount?
• Open to suggestions for more