Search models, users, collections, and posts
TOOLTOP ET693C Protection Cover
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
34 min
1 plate
Open in Bambu Studio
Boost
4
7
4
0
22
20
Released
Description
Protection cover for my TOOLTOP ET693C Super IR Thermal Camera.
It's highly recommended to use a filament which is a little flexible and has very good layer adhesion. PCTG (not PETG) works very well, but PETG may is fine too, as PCTG is not that common. PLA, if it's not a special blend, may is to brittle (never tried).
I also make a nice box to store the camera in (using the original foam insert).
Support my work
If you want to support my work directly, you can buy me a coffee.
Also check out my other models.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (4)