Fairphone 6 case - Free 3D Print Model

Search models, users, collections, and posts

goox

Hobby & DIY>Electronics

IP Report

Print Profile(1)

All

P1S

X1 Carbon

P1P

X1E

H2D

A1 mini

H2D Pro

H2S

P2S

H2C

X2D

A2L

0.16mm layer, 3 walls, 15% infill

Designer

1.4 h

1 plate

5.0(2)

Open in Bambu Studio

Boost

Released

Description

A simple case for the Fairphone 6 / Generation 6 to soften falls and make the feel a little more comfortable.

It has small recessed grips or bumpers at the bottom, as I always have the phone resting on my little finger.

The frame is very tight.

I give no support, will not modify anything and grant liability.

Good luck, have fun.

Comment & Rating (5)

@user_3987689112

Print Profile

0.16mm layer, 3 walls, 15% infill

Usable shell after support removal

The profile uploader has replied

Show original

@goox

Nice. Very first time I see something printed I made. Thanks.

@spicywall

The printing service got back stating that the thickness should be minimum 2mm. Do you think this will be an issue? Or can I go ahead using this model? Asking for an opinion here.

The designer has replied

@goox

Hm. The general thickness in the model should actually be 2mm anyway - only the two strips on the back are slightly thinner, so that I could insert one or two banknotes (that was my plan). Please note - I have noticed a design flaw - most USB-C charging cables cannot be inserted completely through the opening.