Spool Desiccant Holder w/ Rectangular Hygrometer

Based on @KYZ Design's High Airflow Spool Desiccant Holder, with a slot for a rectangular hygrometer. Inspired by @buranowu's remix for circular hygrometers.

A hygrometer this close to the desiccant is going to provide a very localized reading, so the value is mostly to see if the desiccant needs to be refreshed while sealed with your filament.

New print instructions (remix)

Bambu users should be able to use the 3mf profiles. If you are slicing yourself, please follow the print instructions on the original model in addition to these instructions for the new parts.

1. Supports: Print without supports. The hygrometer slot should be bridge-able. It won't be a pretty bridge, but it should complete successfully.
2. Walls: 0.4mm with Arachne. Set Minimum wall width to 65% to avoid a seam at the hygrometer corner.

Original print instructions

• Import the “cap” and “cap mesh" together and put them in an assembly to keep them aligned
• Likewise, import the “body" and “body mesh" together and put them in an assembly to keep them aligned
• The mesh parts should have no walls, no top, no bottom and 50-60% triangular infill (or as you see fit)
• Use 3 walls for all parts, 3 layers for the bottom, 4 layers for the top
• Layer height as you see fit (I use 0.20m)
• Even if you have a fast printer, slow down the outer wall speed for part durability and consistency in gloss level (I use 50mm/s)
• ARACHNE WALL GENERATOR MUST BE ON!