Cockroach

This is a cockroach-shaped magnet featuring a simple linkage mechanism between its left and right wings. Upon assembly, the wings articulate to achieve an approximate 60-degree spread. Weighing under 12 grams, this miniature marvel is easily attainable.

Note: Newly printed models may exhibit slightly increased damping, which typically improves with repeated use. (Due to the wings' delicate nature, forceful manipulation is discouraged initially).

Two integrated D15mm*3mm magnets are included.

Exercise caution during installation to prevent breakage of the pegs. Tool usage is strongly recommended. The designer utilized a vernier caliper to facilitate precise assembly (slightly separating the caliper's jaws to accommodate the peg and securing it on a stable surface). Suggestions are welcomed.

This is a cockroach-shaped magnet with a simple linkage between the left and right wings. After installation, the wings can be spread out at an angle of about 60 degrees. Weighing less than 12g, you can own it.

Note: The damping may be a little large when it is just printed, and it will get better after repeated use (because the wings are relatively thin, it is not recommended to move the wings vigorously in the early stage).

Two D15mm*3mm magnets are built in.

Please be careful when installing to avoid breaking the pile. It is best to use tools. The author used a vernier caliper to assist in installation (slightly separate the two teeth of the vernier caliper to make it slightly larger than the pile body, and press it on a stable table. Meanwhile, suggestions are welcomed).