Fairphone 5 Case - Free 3D Print Model

Search models, users, collections, and posts

Jebob

Hobby & DIY>Electronics

IP Report

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

H2D

A1 mini

H2D Pro

H2S

P2S

H2C

X2D

A2L

0.12mm layer, 2 walls, 15% infill

Designer

1.6 h

1 plate

4.0(1)

Open in Bambu Studio

Boost

Released

Description

Content has been automatically translated.

Show original

The case should be scaled to 100.5% to ensure a snug fit for the phone.

The holes are for the supports, which can be enhanced with a continuous logo on the back.

Comment & Rating (6)

@norog242

Nice one, thank you a lot! Printed one with TPU, scaled it down to 99.75% on the X- and Y-Axis and to 100.1% for Z-Axis. This way it worked for me even in TPU.

The designer has replied

@Jebobmi

Thanks, it was designed for PLA, but good to know that it works with TPU

Show original

@Jebobmi

Nice that it also works with TPU

Show original

@ljfrench

Print Profile

0.12mm layer, 2 walls, 15% infill

Overal a good design. Didn't realize that the backpart was bassicly infil to give a honey comb infill pattern (very cool, my fault for not noticing). So I printed it again with bottom layers so I could use the 3d effect plate. Included a photo of both. Minor issues: Difficult to get on the phone, didn't think of it till after but probably could have put it in warm water so it be more flexible. Yhe vertical fit of the phone is a bit off, so it slightly shakes up and down, but very minimal and I can live with it. Like maybe 1 - 2 mm.