VW T5 Cup Holder V2 - Free 3D Print Model

Search models, users, collections, and posts

TachyTCG

Hobby & DIY>Vehicles

IP Report

Print Profile(2)

All

X1 Carbon

P1S

P1P

X1E

H2D

A1 mini

H2D Pro

H2S

P2S

H2C

X2D

A2L

0.2mm layer, 3 walls, 15% infill

Designer

5.8 h

1 plate

4.7(38)

0.2mm layer, 2 walls, 10% infill

18.3 h

1 plate

4.8(10)

Open in Bambu Studio

Boost

282

740

1.1 k

662

Released

Description

This is V2 of my cup holder for a VW T5 that slots in to the slot bellow the vents on the driver and passenger sides

Boost Me (for free)

All of my models are free to be used commercially so why not boost me to show support?

Comment & Rating (79)

@3D_TomTom

Boosted

Print Profile

0.2mm layer, 3 walls, 15% infill

I printed it twice, but I found the material consumption too high, so I adjusted the settings, colored the symbol, and then printed two more. It also fits very tightly and can only be installed with a little force, so I scaled it down to 99.97%, and then it fit perfectly in my opinion

Show original

@hillbillyxsi88

is there any chance you could send this profile?

@3D_TomTom

Boosted

Replying to @hillbillyxsi88 :

I can gladly add this as a separate profile here this evening I will let you know once I have completed this

(Edited)

Show original

@hillbillyxsi88

great thanks

@darron

Boosted

Print Profile

0.2mm layer, 2 walls, 10% infill

Turned out amazing.

(Edited)

The profile uploader has replied

@3D_TomTom

Boosted

thanks man.!

(Edited)

@user_819271225

this turned out very good and beautiful, I think a ''cup''/mug type version would be nice

Show original

@Flashyyxd

Looks fantastic and fits perfectly in my VW Caravelle. It's like it came with the car haha 😂

The designer has replied

@TachyTCG

Looks great. thanks for the comment

@pepett.hc

Print Profile

0.2mm layer, 3 walls, 15% infill

Just need to test it in the VW T5, However, a small question about the supports, I have some marks underneath, should I wait before removing them? I printed them in SUNLU's PLA+

The profile uploader has replied

Show original

@TachyTCG

sorry I can’t answer in French I hope this helps still. I thought of changing the model so it looked prettier however because the supported areas aren’t visible I wasn’t worried about it and left it as is. hope it works for you as it does for me

@Padge_

absolutely fantastic print. printed in SUNLU PETG 5% infill

@Polletronics

Boosted

Print Profile

0.2mm layer, 3 walls, 15% infill

very good print. fits perfect

@user_356080235

Print Profile

0.2mm layer, 3 walls, 15% infill

Past Perfect Megga druck

@Loganireland06

a lovely attachment for a useless cubby

@koudymaker

Boosted

Print Profile

0.2mm layer, 3 walls, 15% infill

Printed in PETG for a friend's car. A little big for the holes in the T5 and the arm cracked, but it holds. The supports went down nicely so the profile prints well.