Big Brick Wheelchair 500% no support

Someone mentioned making a big brick wheelchair and I thought it was a wonderful idea! So here it is!! Inspired by the popular brick company counterpart, this 500% scale brick wheelchair prints with no supports or ams! The studs for the backs of the legs are 23mm. I will not guarantee they fit any other creator except the original Big Brick Figures which I'll link below. This is an easy print thats fun to assemble!

To assemble

Start with the rear wheels. The tire is flatter on the back, the plain wheel half goes into the back of the tire and the spoked wheel half on the front. Then screw in the hub from the back and repeat for the other side. I recommend checking the threaded parts before assembly. It may help to work them back and forth until it screws in fully.

Next grab the seat and handle. Slide the handle down over the dovetails on the back of the seat and lock it in place with one of the short pins through the front.

Slide the axle stub through the wheel and into the seat, note there is a bigger chamfer on one side. Then lock them in place with the two remaining short pins.

Next insert the tree dowels into the bottom of the seat as shown and place the chair base over the dowels. Lock it in place with the two long pins.

Lastly, take the center block from the front wheels and hold it in the center of the holder. Then thread in each side. As with the rear wheel threads, check them before assembly and work them back and forth if necessary.