Search models, users, collections, and posts
Sonoff NSPanel PRO Stand (45° angle)
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 3 walls, 20% infill
Designer
3.1 h
1 plate
Open in Bambu Studio
Boost
53
177
35
27
491
296
Released
Description
I am using the Sonoff NSPanel on a table where I stand infront the majority of times. So I remixed the nice stand I found on printables and remixed it to an 45° angle. Also increased the cable hole and made some new venting holes.
Boost Me (for free)
If you like my design, you know what to do!
Print settings
Just use normal settings that work for most of your prints. Supports are optional for the screw holes (which are included in the print profile)
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (35)