Search models, users, collections, and posts
Print Profile(1)
0.2mm layer, 5 walls, 50% infill
Designer
1.5 h
1 plate
Open in Bambu Studio
Boost
12
23
0
1
37
9
Released
Description
Not much to say here but this allows me to attach the FX 30 camera to a tripod or gimbal. L brackets are expensive so I designed this. It is very strong and attaches to two points on the camera.
Print on edge with the flat side down.
No supports are necessary.
I use 5 perimeters and 50 % infill
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (0)