Gain Detergent Magnetic Tray for Kenmore Washer

This is a simple tray made for a kenmore elite / electrolux clothes washer to stop near empty detergent bottles from getting shaken on to the floor.

Designed for Gain Liquid detergent.

The bottom has a 3mm riser to fit the lid of the washer and the front has a negative part that can be modified to fit other detergents.

The magnets used were 12mm x 2mm but the profile uses negative parts so you can modify the size if needed.

I only used 5 magnets total; 3 in the bottom  and 2 on the side wall that goes along the side of the washer…but the bottom of the tray has room for 3 additional if I think it needs more hold later.

It prints in 2 parts on 2 plates; a bottom and a top that need to be super glued together.

There are optional 2mm registration holes that an M2 bolt can thread directly into in order to hold the two halves together while glue dries…just make sure they're all the way together and that you catch the hole on both sides otherwise the bolt will just do the opposite and hold them apart.