Search models, users, collections, and posts
Manga Second-Row Shelf-Raiser (IKEA BESTA)
IP Report
Print Profile(3)
Version Kallax
Designer
1.9 h
1 plate
0.2mm layer, 2 walls, 15% infill
Designer
2 h
1 plate
Version Billy
Designer
2.8 h
1 plate
Open in Bambu Studio
Boost
41
122
21
3
132
107
Released
Description
Two rows of mangas fit one behind the other on our living room IKEA Besta shelf. I printed a raised section so that you can also see the second row.
I tried to find a balance between load-bearing capacity and economical filament (pla) consumption. I also wanted the printing to be easy.
The height of approx. 6.5 cm is based on a tissue box. The height is 11.5 cm deep and 18.6 cm wide, so that three units are needed for a Besta shelf.
If other books are to be used, it is advisable to test the structural load in terms of weight
I am always open to suggestions for improvement, as this was my first attempt at my own model.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (21)