This setup is great, the AMS2 variant works perfectly with the AMS2 Pros I have. I may try to scavenge the plate holders from the original design, too, but that's a work in progress. Make sure you have some extra tubing for the AMS if you move it off the top of your printer. Also make sure your plates are clean -- I'm new at this and was having some issues with the little pieces adhering even on the textured plate until I realized I needed to clean the thing. Whoops! Learning curve... :)

Terrific -- takes a 1" wooden dowel and sits nicely on my French cleat board behind my workbench. I printed 3 per 36" dowel set, using some random PLA and PETG. Only thing I'd mention is once there's load on them, check them the next day to make sure they don't slip. I had to lift the front of the shelf and push down on the cleat part to seat them again (but no movement after that). Good stuff, thank you!

My second print ever, right after a Benchy… turned out very well. Did blue ribbon on a white box, smooth plate.