Printed well but found hole pattern about 1mm off still attached easily enough, OEM screws are too short by about 4mm, assembled with 6 50lb magnets and held fine but pulled assy off when removing. OEM screws are too short by about 4mm and pulled out when testing hold, Sourcing longer same style screws and will retest.

Clean Print in my P1S and P2S's. Using SUNLU PLA.

l had to add 1mm to base dimension to stop a full spool from pulling it off the printer, but seems fine now.

Never printed, have found when its 104 out here in Texas the TPU clips dont hold well, Should have read the description first.

Nicely done

Printed by accident but my granddaughter liked it

Good print.

Using as a test bed tool, print is very well done

Printed a few of these, found Kirkland box is a loose fit, but was an easy fix to add a sizing ring. Would recommend a smooth plate it looks nicer. Very nice!

Remixed to suit my use but overall very nice print

So good I printed two

very nice print