Printed two in marble PETG and they came out great! Tip if you print multiples: in the profile the model is intentionally sunk slightly below the build plate so it sits flat. When you duplicate it, the copy may not keep the same Z offset, so lower the duplicate on Z to match the original so both parts align perfectly. I also had to place/rotate them manually (auto-arrange wouldn’t fit two on one plate). Only minor supports needed. Settings: Profile: 0.12mm High Quality @ BBL X1C Changes: Wall Generator=Arachne; Thick Bridges=On; Avoid Crossing Wall=On; Supports=On (Tree Slim, build plate only, critical regions only); Brim=No-brim Print Time: ~ 10 hours

Great profile! Was easy to color teeth and eyes which made for a fantastic looking print!