I couldn’t find this useful AKG USB-C earbuds holder on MakerWorld, so I uploaded it here. It’s a simple but practical design to keep your Samsung AKG earbuds organized, especially if you still use the ones that came with older smartphones. It prints quickly (~40 minutes) and only needs minimal supports under the USB-C connector. All credit goes to the original designer (Mattwall on Thingiverse). Just sharing it here to make it easier to find and use.

I’ve always liked the idea of giving old tech a second life. This adapter was born from that mindset — instead of throwing away classic VHS cases, I wanted to turn one into something useful again. Now it holds a 2.5" HDD inside, combining retro nostalgia with modern storage. The drive shown is a Toshiba Canvio Basics, but the concept works with standard 2.5" drives and typical VHS plastic cases. If you enjoy mixing retro aesthetics with practical DIY solutions, this one’s for you.

I designed this stand to improve airflow and make better use of the vertical space on my desk. It perfectly fits my Chuwi LarkBox X (2023) and leaves enough room underneath to store an external HDD, keeping everything clean and organized. If you’re using a similar-sized mini PC, this might help you tidy up your setup.

I designed this hanger to organize my football scarf collection in a clean and compact way. Instead of stacking them in a drawer, I wanted something that displayed them properly while keeping them easy to access. Two versions are included to fit different printer bed sizes. If you’re a scarf collector, this might be a simple and effective solution.

I wanted to make use of the unused top section of my dual monitor arm’s vertical bar, so I designed this snap-fit platform. It installs without screws or tools and adds a clean way to place a small speaker or accessory above the setup. If you have a similar monitor arm, this might help you add extra functionality without modifying your desk.

I’ve been using this 40mm VESA offset plate on my dual 27” monitor setup for over a year without any issues. My monitor arms didn’t allow the screens to align properly, and the bezels slightly overlapped. This simple offset completely fixed the geometry and allowed both monitors to sit cleanly side by side. After long-term use with no visible deformation or structural problems, I decided to share it here in case it helps others with similar dual arm alignment issues.

Replace your van ceiling trim clips with a functional rotating hook. No drilling, no tools required — just press fit and use. Designed for van life organization and optimized for easy and reliable 3D printing.

This is my first MakerWorld upload! I designed this triple tower holder to organize my 40 mm Mercadona tea lights in a compact and elegant way. It prints easily without supports and keeps candles accessible while looking great on a desk or shelf. Feedback is welcome!