Very good, it keeps all the expansion stuff in one place out of the way (i don't really like it much) and makes it easier to setup. I used the remixed expansion tray.

Thank you for uploading! I glued 6x2mm magnets in the holes with loctite and everything stays in place nicely.

Very good! I'd suggest making the card slots maybe 1mm larger in both directions, my sleeved cards fit very tightly (i use PYN sleeves).

Excellent! PLA kept coming off, so i printed in PETG, smoothed the holes with a drill bit and now it's staying in place.

Excellent! Thank you very much!

Fantastic design! It even leaves a small tolerance for my skadis sideboard hangers!

Printed a bunch in petg, they are perfect. Sometimes they are hard to fit but i think it's a difference in holes tolerance from spool to spool.

Very useful, I was looking for a hanging one since i use the anti-vibration feets and did't feel like using magnets, this one is excellent!

Exceptional! I got rid of the original box and saved a lot of shelf space. The lid doesn't fit perfectly flush because the numbers' stacks are higher than the insert by 1mm or less, but honestly i don't care given how much space i saved. Thank you!

Very nice organizer!

Printed the 2-part version and glued them together, fits perfectly.

Excellent, I needed one of these for my work's toolbox!

My scraper blade's pin holes are not aligned with this model (as stated by others they are flipped and the blade mounts upside down) but i cut them out and the screws are enough to hold it in place.

Extremely useful, much better than the long ones, thank you!

Very nice!

Perfect print, very useful!