Printed in Black Matter3D PETG-HF and Red Bambu PLA basic. All plates printed quite nicely - minor artifacting likely caused by printing conditions rather than profile. Large halves require lots of pressure to get aligned, but won’t be noticeable once loaded with cards. Unsure why all rows are slotted for dividers when drop-in dividers only fit one section, but I could be missing something. Despite not being perfect, this print is more than good enough for the intended application and came out looking great. Once assembled in the Packout container, it almost looks like it came that way! Thanks for taking the timing to remix and configure this - I’d be eager to see additional add-ons available in the future. Also: I created a .3mf for tolerance testing because I wasn’t confident printing the full plate without an initial test-fit. (as seen in last two photos) I can upload it as a print profile if you’d like!

Print profile itself seems great. Very solid and high quality print using Matter3D PLA. As for fitment, I have the 2L outdoor sling and wanted to chime in, as per your request. The buckle size is, in fact, smaller on the 2L. I'll be sure to print this again if I end up with one of the larger size slings, though. If there is anything I can measure to help you design a 2L version, I'll happily do so. Cheers!

Love the auto-pause profile. It was my first try and multicolor without an AMS. The detail looks fantastic on this model, and I look forward to more like it! Thanks for giving me a little confidence boost when it comes to multicolor :)

Printed for a friend who paints DnD minis. Huge fan of how it turned out. Little bit of work with a deburring tool to get the brush holes free of any fringing or strings, but that could be down to my filament choice. Thanks for the model and the profile :) Printed in Polymaker Polylite PLA.

I have printed more of these than I can count. It's fantastic to shave a little time off of each plate. When you have a small build plate like the A1 mini, every minute saved adds up! Cheers.

WOW. I think this is my first time encountering a truly perfect model. The results are a testament to the importance of tuning every little detail. There is a small seam visible, but I'm pretty sure that's impossible to avoid. Printed in ELEGOO PLA+ and I'm thrilled to print in a few different sizes/colors. Thank you for spending the time on such a great model.

Thrilled with the quality and moderate speed of this print. Tiny bits of stringing, but so easy to address afterwards. looking forward to printing and color-coding more of these.

Unsure if I'm doing something wrong, but I get quite a lot of rattle once this is attached. (Even when the bucket is empty) On such a quiet printer, so much high-pitch noise is a shame. **TO BE CLEAR** This print turned out beautifully without any visible flaws, and absolutely serves its purpose. I might even try scaling it down -1% in case the tolerances are just the slightest bit loose where it mounts. For now, I'll place a small bin or print a bucket and deflector combo. Thanks for the well-designed model!

Simple, but so SO helpful. My OCD brain is thrilled with the cleaned-up look these offer. Printed nice and fast with no concerns.

This model alone felt like the final straw for me to get into printing. I have exactly this camera body with bottom plate and have been looking for an elegant storage solution. After stumbling across gridfinity, I was praying something would be compatible with the A7RV. Absolutely perfect. Print profile worked out beautifully. A couple small burs on the tall outer edges, but I'm more than satisfied with the end result.

Fantastic. Originally printed out the smaller size, but didn't fit my application. Used it for a smaller cable and printed the 21mm. PERFECT. Profile is strong and dependable. Holding on well despite a reasonable amount of tension from the cable. I'll be printing a bed full of these.

Big fan of this print to keep in my forester! thinking of printing a few colors to keep and give out to people with matching cars. 😁