One-Piece Printed Fabric Phone Handbag

Copyright Claim

One-Piece Printed Fabric Phone Handbag

Boost
142
287
9

Print Profile(1)

All
P1S
P1P
X1
X1 Carbon
X1E
A1

0.12mm layer, 2 walls, 15% infill
0.12mm layer, 2 walls, 15% infill
Designer
28.2 h
5 plates
3.3(4)

Open in Bambu Studio
Boost
142
287
9
2
104
18
Released

Description

Boost Me (for free)

This design took days to make and fine-tune, help me out by giving me a boost and I can keep working on other bag designs

 

Here is a small, stylish handbag that can hold your phone and other small items.

 

Print the back and front sides of the bag, then push the connectors in to assemble the bag. 

 

Remember to leave room at the top for the hanging loop to press in.

 

Straps from other bags can be used or cheap bag straps can be ordered online.

 

Printed a few in PETG and PLA. Depending on the material type, tolerances can vary. Using a tool to press in the connecting pieces makes it easier. 

You also may need to flex the material back and forth after it's printed to ensure it's completely free and not stuck at any joints.

 

Print the test piece and a test connector to see how the tolerances work for you. They are included on separate plates

 

leave comments with any questions and I'll try to answer.

Comment & Rating (9)

Please fill in your opinion
(0/5000)

I had to force it, even with force it didn’t fit, however, a part broke I won’t print a new one, it takes too long to print Please provide explanations
Show original
0
Reply
Boosted
Print Profile
0.12mm layer, 2 walls, 15% infill
Please tell me the best steps to install it. It broke in 5 pieces so I fixed it with glue. The material is PETG
0
Reply
Looks good but really hard to assemble.
0
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill
No assembly instructions
Show original
0
Reply
Hello, I have printed everything, but the pieces don't fit into the holes, plus there are no photos of the steps and one printed part I don't even know where it goes, please reply
Show original
0
Reply
It looks great! 😊
0
Reply
Boosted
Printing completed Are there any installation instructions?
0
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill
Other Issues:just overly complicated to assemble but I will make a remake of this that I guarantee you will be 100X easier to assemble if not more.
0
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill
Other Issues:I was unable to assemble it correctly
Show original
0
Reply
No more

License

This user content is licensed under a Standard Digital File License.

You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.