One Piece Luffy Straw Hat

Copyright Claim

One Piece Luffy Straw Hat

Boost
2
4
2

Print Profile(1)

All
A1 mini
P1S
P1P
X1
X1 Carbon
X1E
A1

0.2mm layer, 2 walls, 15% infill
0.2mm layer, 2 walls, 15% infill
Designer
8.2 h
2 plates
2.0(2)

Open in Bambu Studio
Boost
2
4
2
0
9
3
Released

Description

Content has been automatically translated.
Show original

Luffy's Straw Hat

Comment & Rating (2)

Please fill in your opinion
(0/5000)

Print Profile
0.2mm layer, 2 walls, 15% infill
Support Issue:Supports very hard to remove under brim of hat. Some are so thin that it is hard to tell where support ends and the model begins.
Strength Issue:The top of the hat is very thin. I printed to the profile provided but the top needs to be thicker. I understand that this is a small model and difficult to get good quality. The overall print when finally finished is nice. If I printed again, I would make a couple changes to make it thicker on the top and help the support removal.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Other Issues:printed all boogered up about 4-5 layer.
0
Reply
No more

License

This user content is licensed under a Standard Digital File License.

You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.