Illuminating Levitation Display

Copyright Claim

Illuminating Levitation Display

Boost
45
123
0

Print Profile(1)

All
P1S
P1P
X1
X1 Carbon
X1E
A1

All Parts - 0.2mm layer, 2 walls, 15% infill
All Parts - 0.2mm layer, 2 walls, 15% infill
Designer
4.3 h
4 plates

Open in Bambu Studio
Boost
45
123
0
0
29
2
Released

Description

Boost Me (for free)

Drop a boost to get better luck balancing the floating piece! :)

The deer on display was created by:

https://makerworld.com/en/models/86094#profileId-94609

CAUTION

Please read through the online overview for tips and important info before beginning this little adventure:

https://us.store.bambulab.com/collections/makers-supply/products/magnetic-levitation-diy-kit?variant=43072975929480

Assembly

Put the stand on the main display. You can glue it if you want. The holes on the bottom are to assist with airflow and keeping the base cool.
Remove the 3D printed case. Place the Magnetic Levitation Base on to the 4 pins. Either glue or use double-sided tape to secure the touch switch to the lid. Make sure the wires are on the opposite side of the notch.
Insert the power cable and secure it using the attached hex screw.
Put on the lid and attach the power cable. BASE COMPLETE.
There are TWO floating display designs. If the object you are displaying does not have an even weight distribution, then print the balancing float display so you can add the stainless steel balls from the kit to counter the weight so it is level. Assembly is the same for both…
Remove the 3D printed case. Insert the coil & Magnetic Levitation Float with the LED light on top. ***The distance of the coil to the base will impact the brightness of the light. You can add the coil support (as seen on the right)  to provide further distance from the base if needed. I found that my light was brighter without the coil support piece. Test out both options and see which is better for you.
Add the lid to secure the LED light & magnet. BE CAREFUL NOT TO PINCH THE COPPER WIRES! Trust me… They break easily.
Add the diffuser lid and you are ready to go! May the gravity gods be with you as you attempt to balance the top piece…

 

This design meets all guidelines and recommended specs suggested by the provided documentation.

Bill of Materials

Maker’s Supply Kits and Parts
Bambu Filaments
A01-K1-1.75-1000-SPLFREE
× 1
A00-W1-1.75-1000-SPLFREE
× 1
Buy Now
Download BOM

Comment & Rating (0)

Please fill in your opinion
(0/5000)

No more

License

This user content is licensed under a Standard Digital File License.

You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.

Get Commercial License