Small Plane Glider

Small Plane Glider

Boost
18
35
9

Print Profile(1)

All
A1
P1S
P1P
X1 Carbon
X1E
X1
A1 mini

0.2mm layer, 2 walls, 15% infill
0.2mm layer, 2 walls, 15% infill
Designer
29 min
1 plate
4.5(4)

Open in Bambu Studio
Boost
18
35
9
2
39
27
Released

Description

Initial layer must be set to 0.2mm for wings to print correctly. Adjust flaps on wings and overall wing angles finely to get this plane flying but ensure wings are as flat as possible upon removing it from print bed! It works best throwing it as straight as possible and does not require lots of input. Keeping the plane as small as possible means it doesn't weigh much so reacts to small changes, continue adjustment until you are satisfied with its flight :)

Comment & Rating (9)

Please fill in your opinion
(0/5000)

Print Profile
0.2mm layer, 2 walls, 15% infill
works well sometimes. other times it just twirls in the air.
The designer has replied
0
Reply
Thank you for printing! I found the same issue unless it was thrown gently, currently working on an update with a larger wing span and readjusted the centre of mass to hopefully make it fly better :)
0
Reply
Replying to @tkeech :
Cool, good luck!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
great balance!
The designer has replied
0
Reply
Thank you so much for printing!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
The designer has replied
0
Reply
thank you for printing :)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
The designer has replied
0
Reply
Thank you for printing!
0
Reply
No more