Remix based off of erer2001's design & Riffnshred's design

Holds 12 20mm bits or 6 regular bits

Print in PETG or PETG-CF

Will need:
Supper glue

Kapton tape

ASSEMBLY:

Slide together the shaft, bit clips and ninja star (between the bit clips), then, slide the whole assembly onto the shaft guide. Screw on the end cap of your choice

To insert the bit holder into the main body, use your fingers to compress the springs and push the shaft/bit holder into the body (about ⅓ in). After that to lock it, rotate it counter clockwise until a loud click is heard. Depending at which position you inserted it you may hear a less loud false click. Simply rotate until a very loud click is heard.

A correctly inserted bit holder will not be able to be pulled off. (Unless you unlock it)

You can rotate it counter clockwise indefinitely. It will simply switch between locked and unlocked state.