Terminator Diagram by Proper3dprints

Awesome print. The only issue I had was a bit of warping on the top right edge. It kept messing up at this one spot so I bumped up the bed temp to 62. Would probably help to either center it better or make it just a tad smaller. Everything was looking fine and then the edge started to peel up. Probably should have turned it down to 55 after it printed the first layer. Still very pleased with it though.

The designer has replied

@Proper3dPrints

the temp i think i too high, also use glue , i use and never had a warp ,it looks unbelievable

@bryzah

Print Profile

0.08mm layer, 2 walls, 100% infill

No more

License

This user content is licensed under a Standard Digital File License.

You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.

Get Commercial License