MFT Table Adjustable Stop

Copyright Claim

MFT Table Adjustable Stop

Boost
9
44
0

Print Profile(1)

All
P1S
P1P
X1
X1 Carbon
X1E
A1

0.2mm layer, 3 walls, 25% infill
0.2mm layer, 3 walls, 25% infill
Designer
2 h
2 plates

Open in Bambu Studio
Boost
9
44
0
0
12
5
Released

Description

Adjustable stop for use on an MFT, or compatible, table-top w/ 20mm Dog Holes w/ 96mm spacing. This one is sized to be going over 2 spaces with an adjustable range of 192 mm. Printed in PETG HF - although expect other filaments will be fine assuming your printer is tuned properly (as sizing is critical for the dog holes).

 

You need to install at least one M5 Threaded insert into the base (although 2 can be convenient for reversing the top without having to remove the base from the table) - I used these https://www.amazon.ca/dp/B0CS6WFCGZ

 

 You will also need an M5 knob (and possibly washer) to hold the sliding top in place on the base.

Comment & Rating (0)

Please fill in your opinion
(0/5000)

No more