Toothbrush holder. 
The main idea of this holder was to create a model that could hold the brush for a long time and not loosen. 
I specifically made two bends so that there would be more material in which energy could accumulate. 
Therefore, I recommend printing it from PETG. 
Use double-sided tape to attach the holder to the bathroom tile. 

And of course, as you like, when you install the brush into position, a satisfying click occurs. :)

No special settings are required in the profile. Just do not make the walls too thin, 3-4 walls will be enough. I just attached the standard Bambu Lab profile.

If you have any questions or suggestions, please write private messages.

Inspired by this project:
https://makerworld.com/en/models/463417?from=search#profileId-371940