Toothbrush head holder for OralB

Toothbrush head holder for OralB

Boost
60
171
6

Print Profile(2)

All
A1
P1S
P1P
X1 Carbon
X1E
X1
A1 mini

0.2mm layer, 6 walls, 25% infill
0.2mm layer, 6 walls, 25% infill
Designer
1.8 h
1 plate
4.8(4)

0.2mm layer, 1 walls, 5% infill
0.2mm layer, 1 walls, 5% infill
19 min
1 plate

Open in Bambu Studio
Boost
60
171
6
2
77
51
Released

Description

Toothbrush holder. 
The main idea of this holder was to create a model that could hold the brush for a long time and not loosen. 
I specifically made two bends so that there would be more material in which energy could accumulate. 
Therefore, I recommend printing it from PETG. 
Use double-sided tape to attach the holder to the bathroom tile. 

And of course, as you like, when you install the brush into position, a satisfying click occurs. :)

No special settings are required in the profile. Just do not make the walls too thin, 3-4 walls will be enough. I just attached the standard Bambu Lab profile.

If you have any questions or suggestions, please write private messages.

Inspired by this project:
https://makerworld.com/en/models/463417?from=search#profileId-371940

Comment & Rating (6)

Please fill in your opinion
(0/5000)

Looks fantastic Does it also hold Philips brushes
The designer has replied
Show original
1
Reply
I'm not sure. I use only oralB at home. But if you take a photo and take a few measurements I can try to adopt the design for it.
1
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
1
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
1
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
0
Reply
No more