laptop stand

Copyright Claim

laptop stand

Boost
25
86
10

Print Profile(1)

All
X1 Carbon
P1S
P1P
X1
X1E
A1
A1 mini

0.2mm layer, 2 walls, 15% infill
0.2mm layer, 2 walls, 15% infill
48 min
1 plate
4.9(10)

Open in Bambu Studio
Boost
25
86
10
6
84
43
Released

Description

just print them in the best orientation, then pop them off the build plate and fit them to your computer side and there you go! 

it shouldn't be to tight a fit, in order to not break or damage the computer. however, it should be tight enough that it won't fall off randomly. there is about 1.4 inches between humps. it looks really big, like it would use a lot of filament, but use about 5% infill on grid and it uses about 10g of filament. 

 

please like my model, and give me a booster token!

Comment & Rating (10)

Please fill in your opinion
(0/5000)

Print Profile
0.2mm layer, 2 walls, 15% infill
work great and easy to pack in my work bag!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Easy print and great / compact solution to get some lift on the back of a laptop. Better than an actual stand in my opinion, just keep in mind you can’t close the laptop without removing them (stating the obvious I know).
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Great Idea! Worked well! Thanks
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply