Heavy Tape Dispenser (One Hand Operation)

Copyright Claim

Heavy Tape Dispenser (One Hand Operation)

Boost
30
64
3

Print Profile(1)

All
A1 mini
P1S
P1P
X1
X1 Carbon
X1E
A1

0.16mm layer, 2 walls, 15% infill, scarf seam
0.16mm layer, 2 walls, 15% infill, scarf seam
Designer
11.6 h
2 plates
4.7(3)

Open in Bambu Studio
Boost
30
64
3
3
39
15
Released

Description

Description

This is a heavy tape dispenser, If you have never used one, a heavy tape dispenser allows you to pull tape from it using only one hand while the other is free to hold the thing you want to secure in place.

The dispenser is designed for tape up to 1 inch wide.

Printing

None of the parts require supports and it is a very easy model to print.

Layer height has very little importance but 0.2 or 0.15 (even better) does make it look nicer.

Printed parts needed are 

  • 1 dispenser body
  • 1 plug
  • 2 pins
  • 1 spindle

The dispenser fits on the Prusa mini as well as The Bambu lab A1 mini…and obviously all other bigger printers.

 

Non printed parts

 

 

  • Something to fill it with:  You will need something to fill it with. Dry sand works great but anything will do, the heavier the better. Make sure you get as much in as you can. Hold the dispenser at different angles and tap it lightly as you fill it to pack it down.

 

Assembly

No glue or anything special required.

  • Fill the body.
  • Screw on the plug.
  • Cut and insert your blade.
  • Stick on your rubber feet or anti-slip surface of choice on the bottom.
  • Insert the pins in the spindle

   And you're done !

Enjoy!

Bill of Materials

List other parts
  • Hacksaw blade x 1: 1/2 inch wide,you only need a piece so find an old one in the garage and cut it to length.
  • rubberfeet x 4: cabinet bumpers work great use 4 minimum
  • Dry sand or other heavy material x 1: To fill the dispenser

Download BOM

Comment & Rating (3)

Please fill in your opinion
(0/5000)

Boosted
Print Profile
0.16mm layer, 2 walls, 15% infill, scarf seam
printed great in Petg-cf. the screw lid was a bit tight, but scaling to 98% fixed it up. filled with BB’s and found some solid feet that will keep it from moving even with the resistance of blue tape!
1
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill, scarf seam
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill, scarf seam
0
Reply
No more