Boxing Wrap Roller * NEW VERSION IN DESRIPTION*

Boxing Wrap Roller * NEW VERSION IN DESRIPTION*

Boost
75
152
13

Print Profile(1)

All
A1
P1S
P1P
X1 Carbon
X1E
X1
A1 mini

0.2mm layer, 3 walls, 25% infill
0.2mm layer, 3 walls, 25% infill
Designer
3.1 h
1 plate
4.8(5)

Open in Bambu Studio
Boost
75
152
13
6
178
84
Released

Description

*NEW VERSION*

https://makerworld.com/en/models/1019223#profileId-1000180

-whats new-

  • overall larger housing
  • stronger spindle that doesn't pinch the band
  • flange that holds the spindle in place (no more friction fit) 

 

 

Boxing wrap roller

  • supports up to 180in wraps
  • 2 pieces
  • no glue necessary
  • pressure plate to flatten wrap

 This is a boxing wrap roller designed by me on CAD, prints in just two pieces that friction fit together (some pressure is required). once fitting together feed the Velcro or loop end of your strap through the slit in the shaft, then through the small slit and then in and through the pressure plate (see pictures above). large gap should be facing down when you are winding the wrap up. then simple pull the wrap off the shaft ( takes a little force). Enjoy! always open to feedback and suggestions 

Comment & Rating (13)

Please fill in your opinion
(0/5000)

Took some time to remove support from center piece. have troubles with removing a full roll afterwards. So i leave a loop on top, it helps. Otherwise all good. can recommend
The designer has replied
2
Reply
I added an updated version that’s much better if you want to check it out
0
Reply
hey mate the supports on the shaft are super hard to remove and make it look bad are there a trick to removing them?
The designer has replied
1
Reply
mine have never come out that rough so I’m not sure..I’ve had some success printing printing them on the edge. so that the handle is touching and just the tip of the shaft is touching.
0
Reply
You are absolutely right, my friend
Show original
0
Reply
when I roll them up, they do not slide out easily
The designer has replied
0
Reply
I’m revising and uploading a new version soon that is stronger and easier to remove the wraps
0
Reply
Print Profile
0.2mm layer, 3 walls, 25% infill
the middle section was very difficult to remove from the support. but once I had it was very well functioning.
0
Reply
Boosted
Works realy nice
0
Reply
Print Profile
0.2mm layer, 3 walls, 25% infill
1
Reply
Print Profile
0.2mm layer, 3 walls, 25% infill
1
Reply
Print Profile
0.2mm layer, 3 walls, 25% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 25% infill
0
Reply
No more