Vase watertight PETG transparent

Vase watertight PETG transparent

Boost
6
24
6
This model is created by Make My Vase
Make Your Model

Print Profile(1)

All
P1S
P1P
X1
X1 Carbon
X1E
A1

0.16mm layer, 1 wall, 0% infill, spiral mode, PETG
0.16mm layer, 1 wall, 0% infill, spiral mode, PETG
Designer
4.7 h
1 plate
3.8(4)

Open in Bambu Studio
Boost
6
24
6
2
17
9
Released

Description

Please check you are using the correct print settings and good quality filament before writing a bad review. With the following settings and good quality PETG i was able to achieve watertightness. I cant guarantee anything, if you don't stick to my settings.

 

A simple, modern, watertight vase. If printed in transparent PETG it looks a bit like glass.

 

In order to achieve watertightness, use included print profile (and 50% print speed) or dial in the following settings on your own:

  • Vase Mode (Spiralmode)
    • Smooth Spiral
  • Use 50% Printspeed (Silent Mode)
  • Material: PETG (watertightness only tested with PETG)
    • Flowratio: 1.04
    • Nozzle Temperature: 265°C (all Layers)
  • Layer Height: 0.16mm
  • Outer Wall Line Width: 0.5mm
  • Bottom Shell Layers: 6

I used Sunlu clear PETG

 

Comment & Rating (6)

Please fill in your opinion
(0/5000)

Print Profile
0.16mm layer, 1 wall, 0% infill, spiral mode, PETG
A very beautiful print, unfortunately not waterproof
The designer has replied
Show original
0
Reply
Thank you for trying it out! It's a shame it didn't become waterproof for you. Did you follow the instructions precisely? The most crucial aspect is slow printing (Silent Mode). I printed my vase weeks ago, and it remains waterproof
Show original
1
Reply
Replying to @sven_vpl :
Oh, I'm sorry, I overlooked that. I will make another print. Thank you for your feedback
Show original
1
Reply
Print Profile
0.16mm layer, 1 wall, 0% infill, spiral mode, PETG
Made something like a shot glass out of it by scaling it down. Came out very nice and is tight.
1
Reply
Print Profile
0.16mm layer, 1 wall, 0% infill, spiral mode, PETG
beautiful. simple but great. I’ll scale it smaller next time but great!
1
Reply
Print Profile
0.16mm layer, 1 wall, 0% infill, spiral mode, PETG
No assistance
Show original
0
Reply
No more