Case Raspberry Pi Camera Module v1.3

Copyright Claim

Case Raspberry Pi Camera Module v1.3

Boost
6
11
0

Print Profile(1)

All
A1
P1S
P1P
X1 Carbon
X1E
X1
A1 mini

0.2mm layer, 2 walls, 15% infill
0.2mm layer, 2 walls, 15% infill
Designer
25 min
1 plate

Open in Bambu Studio
Boost
6
11
0
0
15
6
Released

Description

I wanted a slim no frills case to hold my Raspberry Pi Camera module. It has a ¼ 20 camera mount thread embedded into it. 

 

  • The Front cover is a friction fit.
  • The STL files include a version where the mount and case are in two parts for either remixing or to print combined, but with thicker walls and infill ti support the heat insert.
  • The ribbon cable is threaded into the back before attaching to the camera.
  • You will probably want a dab of glue to hold the circuit board in place, the pins are a loose fit.
  • Or you could squash them down with a hot soldering iron to trap the board.

 

Print settings

  • Printed without supports in a black basic PLA
  • The front and main part of the case had 3 walls and 10% infill
  • The part with the mount had 6 walls and a probably exisve 90% infill. You can probably get away with much less, but I didn't want it deforming when I put the heat insert in.
  • This model acted somewhat as a test print for adding a heat insert.


 

Boost Me (for free)

If you like it, or used it, show your appreciation :) Thanks!

Comment & Rating (0)

Please fill in your opinion
(0/5000)

No more