This box need 4* M3*6 countersunk flat-end self-tapping screws.

here, i use 5mm diameter head, but this value should no more than 5.5mm. 

This is a desktop modular storage system. The standard systrem is includ 2 A1 box, 1 A2 box and 1 A3 box.

Of course, you can build your own system as you like. such as

if you have enbough boxes, you can have a huge system.

The print file have one A3 box. The outer contour size of a single unit is 162.15mm*42mm*88.8mm.

Installation instructions

Initially, it was designed to be a PP injection-molded product, so it could be installed relying on the elasticity of PP plastic. Now, the material used to make it is PLA, which is more brittle in terms of physical properties. Therefore, when installing the drawer, it is necessary to install it at the angle when it is in the open state to obtain more space for elastic deformation

First, install the slide on one side.

Then push the slide on the other side into the correct position.

finally,use screws to fix the positioning piece.

And If you have eight D6*2 magnets and install them in the corresponding positions, you will get a better feeling when opening and closing it. However, if there are no magnets, it won't affect the usage either.

A1 box is available in following link:

https://makerworld.com/zh/models/969835#profileId-941175

A2 box is available in following link:

https://makerworld.com/zh/models/969919#profileId-941260

A4 box is available in following link:

https://makerworld.com/zh/models/1012896#profileId-992552

X Series Desktop Storage Box for IKEA pegboard kit - S1 S2

https://makerworld.com/zh/models/970515#profileId-942045

More functions are currently under development. Please stay tuned.