SWAPMOD AMS TURNING TOP MOUNT RISER FOR A1 MINI

Remixed by

SWAPMOD AMS TURNING TOP MOUNT RISER FOR A1 MINI

Remixed by
Boost
48
125
12

Print Profile(1)

All
A1
P1S
P1P
X1 Carbon
X1E
X1

0.2mm layer, 5 walls, 15% infill
0.2mm layer, 5 walls, 15% infill
Designer
8.8 h
2 plates
5.0(3)

Open in Bambu Studio
Boost
48
125
12
6
46
13
Released

Description

Boost Me (for free)

Any boost is appreciated. Thanks

This is an updated remix of a few models and adapted to work with SwapMod.

 

NOTE

Make sure you print the latest version with the pin to stop the AMS from rotating during printing.

 

https://makerworld.com/en/models/779484?from=search#profileId-716384

 

https://makerworld.com/en/models/898264?from=search#profileId-856718

 

Comment & Rating (12)

Please fill in your opinion
(0/5000)

Print Profile
0.2mm layer, 5 walls, 15% infill
wow works great I love the fact it swivels great design.
0
Reply
I wonder if the weight is not harmful to the A1 mini and affects the stability of the device? Or are my concerns unnecessary? What are your experiences?
The designer has replied
1
Reply
So far so good, but I haven't print that much yet. I will try to really kick things off this week.
0
Reply
Would it be possible to create an A1 mini print profile?
The designer has replied
1
Reply
I tried. The part that attached to the AMS is just a little too tall for that. Sorry.
0
Reply
Boosted
Awesome modification. AS SOON as I can get my hands on the swap mod in the US i plan on implementing it. Can you tell me what was changed to be swap-mod friendly?
The designer has replied
1
Reply
Very easy, you just need to make sure the surface the printer is on is flat.
1
Reply
y is this for a1 mini if u can’t even print on a1 mini?
1
Reply
sorry, but I could not get the version with the pin to work because the pin is too big. The hole is 4.5mm square and pin is 5.5mm square. I did print a smaller pin at 4.2mm square, which fits nicely, but the top and base will not line up properly to allow the pin to slide through both pieces. Can you please take a look? Thanks
0
Reply
Print Profile
0.2mm layer, 5 walls, 15% infill
top :)
0
Reply
What filament did you use for AMS Enclosure? Thank you!
0
Reply
Print Profile
0.2mm layer, 5 walls, 15% infill
0
Reply
No more