Charging Cable Holder

Copyright Claim

Charging Cable Holder

Boost
85
250
9

Print Profile(1)

All
X1 Carbon
P1S
P1P
X1
X1E
A1
A1 mini

0.2mm layer, 2 walls, 15% infill
0.2mm layer, 2 walls, 15% infill
Designer
1.9 h
1 plate
4.2(5)

Open in Bambu Studio
Boost
85
250
9
6
90
48
Released

Description

This is a charging cable holder that mounts to the side of a table or desk with mounting tape. It includes an insert that secures the cables, so when you're done charging, your cable stays in position for next time. I'm tired of hunting down the charging end for all my devices in the dark, this keeps them in position, while still allowing me to pull slack through.

Comment & Rating (9)

Please fill in your opinion
(0/5000)

Print Profile
0.2mm layer, 2 walls, 15% infill
perfect use. Printed with PLA Plus and secured to desk with high temp hot glue
0
Reply
Love this cable holder! I've printed one for everyone in the family for their bedside tables. I used double-sided tape to secure everything. One small issue I had was that the cover kept falling off, so I've added a tongue and groove to each side to hold the cover in place. Remix here: https://makerworld.com/en/models/1092916#profileId-1086724
0
Reply
I wouldn't advise to print it. My usb-c cables slip through and the cover falls of super easy which let's the cables loose so what's the point I wonder?
0
Reply
this is great
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
It needs scaling down so all USB cables stay put, as they slip through the holes. The plugs printed wonderfully though
Show original
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Holes are too large, half my cables can fall back through even with the blocker.
0
Reply
Good & clever design, print with PETG. Unfortunately the holes are too big for a apple lightning cable, so it will not hold.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more