Modular slime (Ghostbusters 2 mood slime if you have pink!) covered bars for your Haslab Ghostbusters Two In The Box ghost trap!
This design is made to be modular, this enables you to print it without an AMS (slime and bars are on seperate plates) and allows you to pick your preferred slime design out of the four I've included.
Once you've chosen your slimes to attach, you'll notice each bar has a cutout and each slime piece has a notch, a small dab of glue on the notch will enable you to fix the slime to your bars, then then pop right on into the trap once the glue has dried.
As with my previous trap bars, some small finishing may be required on the legs / fittings where the supports have been, the same is true of the slime. My personal preferred way to tidy these up is to remove the excess, then using a blue flame lighter (NOT a regular yellow flame one) give the area a quick blast (not even a second) and smooth it over, this also is useful for removing any white plastic stress marks.
The plates have been setup to print the slime at 0.1 and the bars at 0.2 layer heights, this is best for the visual look of each part.
Ensure that the bars are printed vertically to avoid the legs breaking off in your trap (this printing orientation makes them stronger)
For best results, use a smooth / super tack plate, for smoother edges / ends.
Take caution in removing the supports from the slime, as it is purposely thing and could be damaged using the brute force and ignorance technique.
Fitting these is at your own risk, I accept no liability for any damage you could inflict onto your ghost trap.
The filaments used on the printed photos are basic PLA Red and Bambu green
Boost Me (for free)
If you find these useful, a boost goes a long way :)
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (8)