Nintendo Switch Games Case

Nintendo Switch Games Case

Boost
1916
3706
222

Print Profile(2)

All
A1
P1S
P1P
X1 Carbon
X1E
X1
A1 mini

0.2mm layer, 2 walls, 15% infill, use Tree Supports
0.2mm layer, 2 walls, 15% infill, use Tree Supports
Designer
1.6 h
1 plate
4.8(174)

0.2mm layer, 2 walls, 15% infill
0.2mm layer, 2 walls, 15% infill
1.4 h
1 plate
4.9(10)

Open in Bambu Studio
Boost
1916
3706
222
196
3.5 k
2.4 k
Released

Description

A simple Print to store 10 Nintendo Switch games. The box is designed so that the cards do not simply fall out when turned around.

Comment & Rating (222)

Please fill in your opinion
(0/5000)

Print Profile
0.2mm layer, 2 walls, 15% infill, use Tree Supports
nice print. I would add some snap or 'click' lock the lid and perhaps some kind of blockade to stop it from revolving too much when picked up
9
Reply
Oo if someone does a remix with this capability it'd be a hit
2
Reply
Replying to @zenike :
I'm testing one solution right now. Once I get the measurements right I will upload the remix :)
3
Reply
Replying to @radziuw92 :
Can't wait, thank you!
0
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill, use Tree Supports
Very usefull. Print flawless. I hope in a V2 with a way to lock/block the lid when closed
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, use Tree Supports
Print OK. Did the job. I should print the cover in a different color.
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, use Tree Supports
Très pratique !
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
It was a little loose for me. However, I printed it with PA. That may have been the reason. Otherwise a good design. The games are now well protected. Best regards derdeichmann
Show original
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, use Tree Supports
Very practical!
Show original
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, use Tree Supports
printed cleanly and required supports came out and it clipped together very easily. Games readily fit inside without jamming
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, use Tree Supports
I like it a lot, works great
0
Reply
amazing print!!!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, use Tree Supports
perfect!
0
Reply