Folding Pocket Utility Knife

Folding Pocket Utility Knife

Boost
247
516
14

Print Profile(2)

All
X1 Carbon
P1S
P1P
X1
X1E
A1

0.2mm layer, 2 walls, 15% infill
0.2mm layer, 2 walls, 15% infill
Designer
1.8 h
1 plate
4.5(11)

0.2mm layer, 2 walls, 15% infill
0.2mm layer, 2 walls, 15% infill
10.7 h
2 plates

Open in Bambu Studio
Boost
247
516
14
16
262
128
Released

Description

This Utility Knife is very strong and easy to print. All you will need is some glue and one small spring. One from a pen will work. Use the stiffest one you can find.

Comment & Rating (14)

Please fill in your opinion
(0/5000)

Print Profile
0.2mm layer, 2 walls, 15% infill
Great knife I printed it in PETG then I super glued the knife release/insert button holder down and the two halves. It flips open pretty nice too! I used the longer spring holder for more tension but it probably depends on the spring you used.
1
Reply
Boosted
Needs a little work but functional.
(Edited)
1
Reply
Great model, easy to print and assemble, thank you. I printed it on my A1 mini with PETG filament.
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Parts did not stay together
0
Reply
Even with the glue that it needs?
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
it was very hard to assemble but I figured it out
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
I am experiencing problems
Show original
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply