A little brick-inspired mascot to keep you company.

Printing tips:

• No supports needed.
• Top surface pattern = Concentric.
• Reduce outer wall and top surface speeds for more consistent surface finish from top to bottom of the model.
• Low infill percentage (5-10%) is fine but can be increased to add mass to the body if desired.
• The head can be printed separately (see “Separate Body & Head” .stl file) allowing it to rotate.
• If the model detaches from the bed during printing, try in this order:
  • Washing build surface with soap and water (if using textured PEI)
  • Reducing inner wall and infill speeds as in the provided print profile
  • Increasing bed temp by 5-10 deg
  • Adding an outer brim of 5-10mm (a last resort that will necessitate tedious post processing of the legs)