I'm asking since I can hear water splashing around inside the hull/support areas.. Pouring out the water and you can restart for another 60s burst of fun, and then rinse and repeat.. However, the water inside the model doesn't drain so well, so that needs fixing.
I also need to increase the water displacement, as water line was too high and made water leak in to the motor and batteries. I'll likely increase the angle of the motor and propeller drive shaft as well, to get the motor further up from the water.
Remaining steps:
The design uses the 030 Micro DC Motor, the AAA Battery Terminal Kit and 3pcs of the 3x8mm self tapping screws from the Maker's Beginner Kit.
Printed and fit for A1 mini, no AMS needed, all parts fit on one plate.
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (3)