Jura S8 Bean Hopper

Jura S8 Bean Hopper

Boost
0
2
0

Print Profile(2)

All
X1 Carbon
P1S
P1P
X1
X1E
A1

0.2mm layer, 2 walls, 15% infill
0.2mm layer, 2 walls, 15% infill
Designer
5.2 h
1 plate

0.2mm layer, 2 walls, 15% infill
0.2mm layer, 2 walls, 15% infill
Designer
6.8 h
2 plates

Open in Bambu Studio
Boost
0
2
0
0
4
1
Released

Description

Jura S8 "aftermarket" larger volume bean hopper. It has a cutout on the left side for the water tank lid to stand upright while refilling. I believe it now holds well over 1.5 lbs of coffee beans although I have not measured this precisely. Just a best guess at this time. It snaps into the existing bean hopper tightly as there are clips that snap under the bean hopper ring. The lid is where I ran out of gas and was the first printed one and decided to go with it. I wanted to try and incorporate the original bean hopper lid in the future if possible.  

Comment & Rating (0)

Please fill in your opinion
(0/5000)

No more