Leatherman Skeletool Hammerbits Mod

Remixed by
Copyright Claim

Leatherman Skeletool Hammerbits Mod

Remixed by
Boost
31
50
12

Print Profile(1)

All
P1S
P1P
X1
X1 Carbon
X1E
A1
A1 mini

0.20 Strength, lots of walls
0.20 Strength, lots of walls
Designer
17 min
1 plate
5.0(8)

Open in Bambu Studio
Boost
31
50
12
12
57
38
Released

Description

Remixed the Skeletool hammer to hold 2 extra bits in the carabiner/bottle opener.

Video of it in action: https://www.instagram.com/p/DELgBNCuuYD/


v2 already available
extra plastic around the pin-hole & less… uhhh “glitches”?  The model is smoother, fits better & more clicky, also the installed bit acts to lock the top from opening when the skeletool is closed - print standing up on the larger flat end, not the hammer end, pin hole at the bottom.  It's stronger that way.  Bottom part is unchanged, absolutely perfect in every way.

 

The bottom part snaps in place like in the picture, the little curve going “down” against the handle of the Skeletool, it should firmly snap in place, no glue required.

 

Use a li'l superglue when putting the pin in the top part & make sure the groove on the pin is rotated to allow the bit that's installed on the Skeletool to slot in place when the tool is closed - give it a good squeeze before the glue sets.

 

If the bits are getting stuck when opening, you may need to pinch the bits with your fingers thru the carabiner sides to hold them in place while you open it. I figure it'll loosen up with use so I didn't make it more roomy inside.

Comment & Rating (12)

Please fill in your opinion
(0/5000)

Print Profile
0.20 Strength, lots of walls
These print great in any filament. I printed a couple of different colors for friends. I printed mine out of PLA-CF.
The designer has replied
1
Reply
Lookin' sharp! I'd like to see all y'alls together!
(Edited)
0
Reply
Boosted
Print Profile
0.20 Strength, lots of walls
Fit my leatherman perfectly!
0
Reply
pretty cool but you can open a beer because of the bit holder. So I took that part out. the hammer end fits great tho
The designer has replied
1
Reply
can't
0
Reply
I just use the pliers to open a beer if I gotta. If you just want the hammer part & not a bit holder, look at the model this was based on, it's a lot tougher https://www.printables.com/model/207640-skeletool-hammer
0
Reply
Print Profile
0.20 Strength, lots of walls
printed in PETG, perfect fit.
0
Reply
Print Profile
0.20 Strength, lots of walls
1
Reply
Print Profile
0.20 Strength, lots of walls
1
Reply
Print Profile
0.20 Strength, lots of walls
1
Reply
Boosted
Print Profile
0.20 Strength, lots of walls
1
Reply
Boosted
Print Profile
0.20 Strength, lots of walls
0
Reply
No more