Card Deck Holder

Card Deck Holder

Boost
218
544
22

Print Profile(1)

All
A1
P1S
P1P
X1 Carbon
X1E
X1
A1 mini
H2D

0.2mm layer, 2 walls, 15% infill
0.2mm layer, 2 walls, 15% infill
1.1 h
1 plate
4.0(1)

Open in Bambu Studio
Boost
218
544
22
15
432
289
Released

Description

Card Deck Holder

Might need scaling depending on the exact dimensions of your deck. All tests were printed in TPU. Using TPU makes sure the cards fit even better.

Comment & Rating (22)

(0/5000)

The print profile is no longer public
The description says to scale before printing. I did not. I will need to reprint. It fits my smaller cards but not my bigger ones. The design is great!
2
Reply
I made the same mistake, unfortunately.
0
Reply
The print profile is no longer public
easy quick good print.
2
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
it is a bit snug for 52 playing cards.
0
Reply
The print profile is no longer public
Quite good, although the clasp is somewhat loose
Show original
0
Reply
The print profile is no longer public
0
Reply
I printed one and it didn’t work and it couldn’t fit the deck of cards but in general good design if it was just a little bigger, it would’ve fit.
0
Reply
The print profile is no longer public
too small for my full deck of cards
0
Reply
The print profile is no longer public
cool
0
Reply
The print profile is no longer public
my issue was that it doesn't snap or seal and it opens all the time so easily and spills out.
0
Reply
The print profile is no longer public
did not for cards
0
Reply